- #Design of microstrip antenna in cst microwave studio software
- #Design of microstrip antenna in cst microwave studio professional
The evolution of wireless technology has made this whole process very simple. In order to contact a remote area, the wiring has to be laid down throughout the whole route along the valleys, the mountains, the tedious paths, the tunnels etc., to reach the remote location. A “directional” antenna usually is intended to maximize its coupling to the electromagnetic field in the direction of the other station. Some antenna types have a uniform radiation pattern in the horizontal plane but send little energy upward or downward. (Antennas are reciprocal, so the same effect occurs for the reception of radio waves.) A completely uniform omnidirectional antenna is not physically possible. Radio waves are electromagnetic waves that carry signals through the air (or through space) at the speed of light with almost no transmission loss.Īntennas can be classified as omnidirectional, radiating energy approximately equally in all directions, or directional, where energy radiates more along one direction than others. OVERVIEWĪntennas are required by any radio receiver or transmitter to couple its electrical connection to the electromagnetic field. The antenna may refer broadly to an entire assembly including support structure, enclosure (if any), etc., in addition to the actual functional components.Ī receiving antenna may include not only the passive metal receiving elements but also an integrated preamplifier or mixer, especially at and above microwave frequencies. Until then wireless radiating transmitting and receiving elements were known simply as “terminals”. In Italian, a tent pole is known as an antenna centrale, and the pole with the wire was simply called an antenna. Occasionally the equivalent term “aerial” is used to specifically mean an elevated wire antenna The words antenna and aerial are used interchangeably. “Antennas are essential components of all radio equipment.” In reception, an antenna intercepts some of the power of a radio wave in order to produce an electric current at its terminals, which is applied to a receiver to be amplified. In transmission, a radio transmitter supplies an electric current to the antenna’s terminals, and the antenna radiates the energy from the current as electromagnetic waves (radio waves). In radio engineering, an antenna is an interface between radio waves propagating through space and electric currents moving in metal conductors, used with a transmitter or receiver.
A comparison between simulation and measurement results has been made. The simulation and measurement results show a few differences for both of the material substrates. Vector Network Analyzer (VNA) was used to measure the manufactured fabricated antenna to obtain the measurement result.
#Design of microstrip antenna in cst microwave studio software
The antenna is optimized to improve the performance measures like gain, return loss and efficiency.Ĭomputer Simulation Technology (CST) microwave studio software is used to analyze the radiation pattern of the antenna before fabricating the antenna. This antenna will work on IEEE 802.11 WLAN, 2.4 GHz band. The microstrip antenna is designed with the dielectric substrate as Rogers RT/droid 5880(tm) with ɛr = 2.2.
Here we used computer simulation technology(CST) Software for designing and analyzing antenna Finally, the main objective of our project is to design a microstrip antenna and Transfer the data using wireless transmission as a medium and store the data. We are using Embedded for data transmission via IoT(Wifi-module). Here we are integrating Embedded and IoT. The aim of this project is to design a microstrip antenna. This project will discuss the microstrip antenna. The cost of fabrication is also low and can be in large quantities. This type of antenna is lightweight, has low volume and has thin profile configurations, which can be made conformal. microstrip antenna has several advantages compared to other antennas.
The project is about designing a microstrip antenna using different modes of feeding techniques and integrating it with embedded and IoT for wireless applications.
#Design of microstrip antenna in cst microwave studio professional
Project Title: Designing of Microstrip Antenna for Wireless application by integrating Embedded and IoTĪ Final year project on “Designing of Microstrip Antenna for Wireless application by integrating Embedded and IoT” was submitted by Bhavendra chowdary Swarna (from Lovely Professional University, India)to.
0 kommentar(er)
